![]() The 1st step in the process is to identify the problem and this can not be done at your premises, so bringing it to us lets us diagnose the issues and then quote you a price. If your drive has bad sectors then care must be taken not to loose any more sectors as this is where your valuable Data lives, our advanced equipment is designed to repair and recover drives with bad sectors and 90% of the time we can recover your data for a small fee compared to other recovery service providers in Brisbane or Australia. Recovering your data from a failing hard drive If the damage to your HDD is physical and a clean room is required, then the recovery cost can increase significantly as the cost of a clean room recovery runs at $900 upwards depending on the problem. So by running these scans on your hard drive you are making it more difficult to retrieve the data as a physically damaged drive should only be accessed on the lower level and not via windows. Sure there are plenty of cheap data recovery software applications out there but this will normally do more damage to the drive as it will most likely have multiple bad sectors or firmware issues and this is where the drive just can not be read. We Recover Data from Failed Hard Drives, Solid State Drives USB Drives and Phones If you think your hard drive or SSD drive is faulty, visit our store for a quick assessment and we can provide you with professional advice and recommendation. Located on the Northside of Brisbane at Shop 5 / 17 Blackwood Street, Mitchelton you can drop off your hard drive for us to diagnose. This is a free diagnostic service and we can then advise on the best action to take to recover your data. We have the equipment onsite to quickly test a faulty hard drive and give you a clear direction with a way forward to data recovery in Brisbane. We can also do board level repairs to the electronic circuit boards that are attached to your drive, we have the tools to swap Rom chips when replacing a circuit board or even replace diodes where required. We have specialised equipment to carry out the imaging of your damaged drive which gives us a status report on the current condition of the hard drive. We will make a binary copy of your hard disk to a new disk before attempting any data recovery, this reduces the risk of further data loss due to stressing the drive that is already failing. You will only make the recovery process more difficult, and if the drive has problems with the heads, you could damage the platters of the disk making it impossible to recover anything from the drive. The first thing we will do is make an image of the drive on specialised equipment and only then will we start the recovery process. ![]() ![]() The first thing to do is switch off the computer as continuing to use the computer can potentially loose more data or damage the hard drive further. ![]() My Hard Drive is Not Working What Should I Do? ![]()
0 Comments
Leave a Reply. |