![]() ![]() The domain name can be found under the heading Partition. This list appears only if you have multiple domains in your forest and each domain is represented by a step. On the far-left side of this area, you might have a list titled Step #. When you select a row, the bottom of the Operations tab is updated to show the details of that run. Don't investigate warnings until you have addressed errors. If you have errors, this message is usually only a symptom. The run finished, but some data is not in the expected state. The run finished, but there are errors (fewer than 5,000) that should be investigated. The run was automatically stopped due to the large number of errors. This might happen, for example, if the remote system is down and cannot be contacted. Here's a quick summary of the most common statuses in order of investigation priority (where * indicates several possible error strings). The Status column contains the most important information and shows the most severe problem for a run. You can change the sorting by clicking the headers. Look for any run that does not show a success status. ![]() By default, the operations log keeps information about the last seven days, but this setting can be changed with the scheduler. The top half of the Operations tab shows all runs in chronological order. This tab shows the results from the most recent operations. The Operations tab in Synchronization Service Manager is where you should start your troubleshooting. Start Synchronization Service Manager before you begin these steps.
0 Comments
Leave a Reply. |